Whistler Pro 68 Laser Radar Detector

360-degree, total-band protection. Click to enlarge.

Filter Mode
There are times when a radar detector can emit the same frequency as police radar and can cause your detector to falsely alarm. Sometimes a detector can display a signal when picking up another radar detector in vehicle close by. The Whistler Filter Mode checks the signal to verify if it's a legitimate police radar or a false alert from another detector.

INTELLICORD Ready
Add the Whistler INTELLICORD and you'll be able to remotely control the radar detector in settings such as power on/off, city modes, dim/dark and quiet/auto quiet with a simple press of a button.

Patented POP Mode Detection
There are new guns out there that operate just like the instant-on guns of the past but with a very tough new twist--POP mode! This new gun is a normal K and Ka band radar gun detectable by most radar detectors made in the past 30 years until it's in POP mode. When the gun is in POP Mode and activated, a brief burst of energy, less than 1/15 of a second, is transmitted and the vehicle's speed is quickly acquired. A detector without POP Mode detection capability cannot respond to this brief transmission. All PRO Series have POP mode detection capabilities.

Twin Alert Periscope
Whistler's new Twin Alert Periscope provides an added attention getting visual alert. The two extra LEDs flash on and off when the unit alarms to provide a unique visual alert.

Twin Alert Periscope features two extra LEDs that flash for a unique visual alert. Click to enlarge.

View Pro-68 controls. Click to enlarge.

3 City Modes/Highway Mode
Highway mode provides full audio and visual warning of laser/radar systems while maintaining full sensitivity. Highway mode is the default setting of all Whistler's laser/radar detectors. City mode helps reduce the annoyance of automatic door openers and burglar alarm alerts by providing an initial alert (same distance as Highway Mode) then remaining quiet unless the signal strength becomes very strong. When the signal increases the unit will alert briefly to notify you of the change in signal strength.

Stay Alert
The Stay Alert feature is designed to test a driver's alertness. Within 30 to 60 seconds after the feature is engaged an alert is sounded; to show alertness, the driver must press the volume, city or the mute button within 3-5 seconds. If a button is pressed within 3-5 seconds, the cycle is repeated. If a button was not pressed within 3-5 seconds the unit alarms at full volume and the display shows an unique visual alert.

Quiet/Auto Quiet Modes
Pressing QUIET before a signal is detected engages Auto Quiet Mode, which automatically reduces the audio level after the initial warning to a low audio level setting. Pressing QUIET during a radar/laser encounter silences audio alerts, while allowing visual alerts to keep you informed.

Alert Priority
When two or more signals are received at the same time, the alert priority is: Laser, VG-2, Speed Radar, Safety Radar.

Example: If X band is alerting, then suddenly a VG-2 signal is detected, the VG-2 warning will override the X band alert.

Vehicle Battery Saver Mode
The Vehicle Battery Saver Mode automatically shuts off your detector within 3 hours if you forget to turn it off. The timer is reset if the detector is turned off, unplugged or any button is pressed before the 6 hours have expired. The detector will alert you with an audible and visual warning before it shuts off.

Safety Warning System--SWS
This relatively new radar is not for speed detection at all, it is used to keep you informed of highway safety. Transmitters are installed and programmed (for example: in emergency vehicles) to make you aware of possible situations that may require your attention, such as: ambulance vehicles that are moving or stationary, road hazards ahead, road construction delays or detours, etc.

What's in the Box
Whistler Pro 68 Laser Radar Detector, Power Cord, Direct Wire Kit, Windshield Mount, Dash Pad